|
|||||||
| General Forum Open Discussion of the VEX Robotics System that can be answered by anyone. VEX Robotics Engineers will not answer questions posted here; see Official VEX Technical Support below. |
 |
|
|
Thread Tools |
|
|||||||
| General Forum Open Discussion of the VEX Robotics System that can be answered by anyone. VEX Robotics Engineers will not answer questions posted here; see Official VEX Technical Support below. |
|
|
|
Thread Tools |
|
#1
04-04-2012, 12:52 PM
|
|||
|
|||
Using Smart Tasks in EasyC V4 and Integrated Encoder Modules
If you have not seen the Integrated Motor Encoders (IEM), you really MUST!!! Combined with the Smart Tasks in the latest versions of EasyC v4, programming a sensor-controlled autonomous has been reduced to a straight line program. For more on the IEM and Smart Tasks I have added some pages to the http://simplerobotics.org web site. A good place to start is : http://simplerobotics.org/Programming_Smart_Tasks.htm
|
|
#2
04-12-2012, 07:33 AM
|
||||
|
||||
|
Re: Using Smart Tasks in EasyC V4 and Integrated Encoder Modules
I was looking for a tutorial on how to use the new IME, and then I found this... This guide is REALLY helpful and really well made too. Thanks so much for this!
Last edited by diegohuyke; 04-12-2012 at 06:18 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
