V5 Motor Problem

  1. last week
    Deleted last week by Nathan
  2. Shard

    Jan 8 New York 1353C

    on the second photo, the right side is underneath a standoff. try putting it above, or put the left one under

  3. Ozzy LaCelle

    Jan 8 Vancouver, Washington 3249P Pure Talent

    I am on his team and we took off the chain on the chassis and the motors were going really slow. We don't know what the problem is.

  4. Nathan

    Jan 8 United States of America 3249P

    Problem solved.

  5. meepmeepme

    Jan 8 Honolulu, Hawaii (Saint Louis ... 42700B/C
    Edited last week by meepmeepme

    what was the problem and the solution @Nathan?
    I've had motors moving slowly and even stop working. In the cases which I have experienced it was due to the axle moving out of the hole, but I would like to hear your problem so if I have that same problem I can add that to my list of things to do when troubleshooting.

  6. Ozzy LaCelle

    Jan 8 Vancouver, Washington 3249P Pure Talent

    @meepmeepme I am on the same team as Nathan.
    Well, when we programmed the robot the motor color is red torque motor and he did not put that in the program as a red torque motor.

  7. meepmeepme

    Jan 8 Honolulu, Hawaii (Saint Louis ... 42700B/C
    Edited last week by meepmeepme

    @Ozzy LaCelle and what problem did that cause? Just low performance? I haven't set motor gearing software side yet.

  8. Ozzy LaCelle

    Jan 9 Vancouver, Washington 3249P Pure Talent
    Edited last week by Ozzy LaCelle

    @meepmeepme It caused the motor to spin a lot slower than it would when it was programmed as the motor gears that it was supposed to.

 

or Sign Up to reply!