Hey everyone,
I was looking at the motors and I noticed that we have a bunch of 2 pinned motors and we only have a few two to three pin converters is there anything that I’m missing and is there a way to do this without the converters or is this the only way to do it?
The cortex has two 2 pin slots(1 & 10) that you can plug the motor wires into withought the converter (called a motor controller btw) but you have to use a motor controller for the rest of the motor ports(2 - 9).
Here are a few articles I wrote about this very topic:
https://renegaderobotics.org/what-are-motor-controllers/
https://renegaderobotics.org/wiring-basics-part-1/
https://renegaderobotics.org/wiring-basics-part-2/
https://renegaderobotics.org/motor-ports-spread-out-the-load/
https://renegaderobotics.org/motor-ports-1-10/
Hope you find some of them helpful.