Every time i shoot a ball my fly wheel speed starts to decrese. I rewired every thing to see if that was the issue but it was not so i then incressed the speed on the program and it did not work at all.
Your PTC’s are overheating. What setup do u have?
Insufficient power (less than 4 motors), too much friction, and too high of a gear ratio can cause this.
Insufficient power (less than 4 motors), too much friction, and too high of a gear ratio can cause this.
Ya well I recommend using graphite on the bearing blocks, aligning pillow blocks, and using low strength gears. Bam Michael, My suggestion was a whole quarter of a line longer. XD