Hi, I’m helping out at a STEMclub at a local school and they have a VEX Clawbot, with a EDR cpu. I suggested they used the graphical programing in RobotC since they wanted some thing Scratch like. When I did a test install on my own laptop at home this looked like it would be just what they needed, all the graphical functions in the following groups where available in the list on the left:
Line Tracking
Motor Commands
Program Flow
Remote Control
Sensors
Simple Behaviours
Sounds
Timing
However when we installed RobotC on a school computer only the groups Program Flow and Timing where available so none of the other commands could be accessed.
This is obviously an issue for us and I wondered if anyone else had seen this or have a fix or workaround for it?
Cheers
Ben