How to code inertial sensor with block code?

[Mr.Bob_97435E]

How to code a inertial sensor to help with turning?

[Foster]

Search to the rescue!!

How To Use Inertial Sensor

Inertia.setHeading(0, degrees); while(Inertia.heading(degrees > 90)){ Drivetrain.turn(left); } This doesn’t work. It gives me an error for the >, and if I remove it, there is no error, but it doesn’t fulfill my purpose. How would i make it so that the robot turns until the sensor reads 90 degrees? Also, if I were to successfully do this, would it make completely accurate turns?

There are tips on how to put it into the drivetrain to make the programming less work, and a tip to look at the examples that come with the software.

[Mr.Bob_97435E]

I code in block code bc I ngl only know a bit of python soooooo…

[Hunsakers-9636B]

Configure the inertial sensor as part of the drivetrain and use the drive heading block to refer to the inertial sensor when putting in directional values

[Mr.Bob_97435E]

ty 20 charrrrrrrrrrrrrrrrr