I am using VexCode V5 text 1.0.3. Our robot is using an inertial sensor. It is programmed to turn 90 degrees to the left. It is turning, but too far. Looking for some advice. //The robot turns to face the goal. FL.spin(directionType::rev, 20,velocityUnits::pct); BL.spin(directionType::rev, 20,vel…

[image] Rebels1: It is turning, but too far This is expected behavior to some extent, since the motors take some distance to stop, and take longer to stop the faster they’re spinning. So, if you go from full speed to 0% speed when the robot has turned the target distance, the motors with “coa…

Thanks for the input, but we did try most of this. It only turns at 20%, we are using brake, not coast, and had the same problem with the drivetrain. It is not slight overshooting either, it is about 45 degrees too far. We did not try a PID though. We will look into that. Thanks.

You are sleeping for 5 sec after the desired turn, with the motors still running.

There is also a hold braking function that @holbrook suggested using. The stopping code would look something like this instead. FL.stop(brakeType::hold); BL.stop(brakeType::hold)); FR.stop(brakeType::hold)); BR.stop(brakeType::hold));

Inertial Help

VEX V5 General Discussion Technical Discussion

weilin January 5, 2020, 8:23am 6

Another option is to have multiple segments. You turn at higher speed first but only 90% of the way, then turn remaining 10% at the lower speed.

If that doesn’t work you could start exploring using drivetrains