Would a robot that is 5-6 millimeters too long pass inspection?
Or should we bring out the sander
Would a robot that is 5-6 millimeters too long pass inspection?
Or should we bring out the sander
no, the size limit is under 18x18x18" no exceptions.
Even the head of a screw zip tie will fail you inspection if outside the constraints. 5-6mm is a definite fail.
Remember, the inspectors have a tool which needs to pass cleanly over the robot front to back and left to right.
That’s almost half a centimeter
Alright, I think I have an electric sander
i believe this is helpful its what i had to do