Dremel or Angle Grinder

[Cmills1352]

Have 1.5 hp angle grinder. Fun to use. 11/10 recommend one. I havn’t touch dremel months.

[_SPR_JP]

Have 1.5 hp angle grinder. Fun to use. 11/10 recommend one. I havn’t touch dremel months.

Have you built in months?

[Jasper_MCC]

I prefer a hacksaw over a power tool. If the piece is properly clamped in a vice the cutting goes very quickly and comes out very clean. I challenge you to cut through a c channel with a dremel faster than I can with a sharp hacksaw.

I am guessing you mean cutting to length here, not making 1x1 L…

And since I recommended an angle grinder above, I will just say my time from power switch on to power switch off is less that 3 seconds.

Wasting material in the name of science is not wasting!