I asked the product designer who worked on the 2" Omni Wheel to spin up a little graphic to help show some of the intricacies/secrets of the wheel. Basically, this graphic should help anyone else come to the conclusions @u89djt & I did above, albeit much easier. It’s relatively quick and dirty, but gets the point across better than any of my textual ranting has been able to. He even tossed in a trick that hasn’t discussed here yet - cutting the inserts to help create even more clocking positions! If you make two quick trims to the included inserts, you can quickly achieve the same 15degree clocking ability that is exhibited when these wheels are used on the 1/2" Hex Bore.
These inserts were cut using pretty standard diagonal cutters. Be careful & use safety glasses! The cut-off from our inserts went FLYING!
